Trim Tabs

Trim Tabs 

Here at NuWave Marine, we carry essential boating accessories like trim tabs to help your watercraft reach top speeds while also keeping you and your passengers safe. Whether you’re in need of conversion kits or are in the market for trim tab parts and hardware, you’re sure to find what you’re looking for among our wide selection.  

Our customers can have confidence in our quality products from the biggest names in the boating industry. You can also count on us for expert tips and information, as we’re always happy to put our knowledge and experience to good use to assist boaters and mechanics.  

Do You Really Need Trim Tabs on a Boat? 

Boat trim tabs are helpful in many scenarios that may arise on the water. If weight is not distributed evenly on the vessel, which is often the case when carrying passengers, tabs can help prevent listing to one side or the other. They can also help decrease drag on the hull when the boat is increasing in speed.  

With a reliable set of trim tabs for boats from NuWave Marine, you can expect the following benefits: 

• Greater fuel efficiency 
• Enhanced visibility 
• Better handling of the boat 
• Decreased engine wear 

By installing tabs on your watercraft, you’ll enjoy improved performance and safety, two key aspects of a fun and fulfilling boating experience.  

What Is One Purpose of The Trim Tab? 

Trim tabs help offset common variables that can arise when boating. By manipulating the two metal planes located at the rear of the boat, you can better navigate through rough water or correct imbalances caused by improper weight distribution.  

These boating accessories consist of a few components, including trim tab pumps and trim tab indication controls, and NuWave Marine carries kits that contain all the necessary elements to get you started.   

How to Install Trim Tabs on a Boat 

Proper positioning is key to top performance, so tabs should be installed on the further edges of the transom on each side. Aim for a two-inch clearance between the inside of the tab and strake edge. As for the chine, it should be one to four inches from the outside edge of the tab. 

When it comes to trim tab actuators, it’s important for the bottom of the hull to protrude under the tab. Additionally, the trailing edge should be approximately three quarters of an inch above the bottom of the hull.  

For boats that use outboard motors, exercise caution when installing trim tab kits to avoid getting too close to the gearcase. In general, there should be a clearance of at least eight inches between the trim tabs and the center line of the drive to ensure the propeller can generate the proper flow of water.  

Shop NuWave Marine for Dependable Boating Parts and Equipment 

Check out NuWave Marine today to learn more about electric trim tabs and the benefits they offer boaters. We can also help you find trim tab replacement planes and other components should your existing tabs experience defects or wear. Contact us today to learn more or to see our selection of equipment and supplies for yourself.